Loading... Please wait...
Need help? Call us on 01704 531556 Free UK delivery on all orders
Menu
  • Free UK Delivery on All Orders
  • 30 Day Hassle Free Returns
  • Expert Advice & Support

Water Gem DIY Under Sink Filter System With Extra Filter

by

|SKU: WGVP
£45.98Inc. VAT
Availability: Usually shipped within 24 hours- Free Uk Mainland Postage

Product Description

Water Gem Under-sink Filter System Kit with an Extra Filter (2 filters)

Our new Water Gem 1 Year Value Pack contains an extra filter for convenience and to save you money, otherwise the kit is the same as the Original Water Gem with a long reach tap and installation kit included to provide you with freshly filtered water from a dedicated tap in your kitchen.

Everything needed for an easy DIY installation is included (though you will need access to a drill).

The filters contain Granular Activated Carbon to reduce chlorine and other chemicals that make their way into the mains water supply and also polyphosphate which reduces scale forming minerals so you can fill your kettle from your Water Gem tap to stop it from scaling up in hard water areas.

Quick & easy to install, the Water Gem provides 'bottled water' taste at a fraction of the cost.

  • Six month filter life
  • Easy DIY installation
  • Built-in scale inhibitor
  • Constructed from WRAS approved materials
  • Reduces chlorine taste & odour
  • An alternative to buying in bottled water and helping with the environmental fight against plastic pollution. The system also helps reduce any microplastics in your drinking water larger than 5 micron.

FREE REFILLABLE WATER BOTTLE WITH ANY SYSTEM BOUGHT- AWT ARE SUPPORTING #OCEANRESCUE

It is quite easy to fit this system yourself. A lot of people are under the misconception that they would need a plumber to fit the system which is not the case. The saddle valve that makes the connection from your cold water pipe is self- piercing and can be easily fitted yourself using the below instructions.

   Full instructions are provided with the system

 Identify the mains cold water pipe, using a section that is straight and free from paint, scratches or dents. Connect the saddle valve to the cold-water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. DO NOT OVER TIGHTEN. One or two spanner turns after finger tight should do. The aim is simply to make the saddle valve immovable on the pipe.

 Once saddle clamp is secured firmly on the pipe, turn the T bar tap on the saddle clamp clockwise until is stops turning. (This will pierce the pipe with a metal pin – invisibly). Turning the T bar tap a few turns back will allow the water flow. Only do this when you are ready to ‘start up’ the system.

The Faucet tap is also straight forward to fit by following the below instructions.

Select a position for the tap on the counter or sink shoulder, you may already have a removable cap that will reveal a hole for your tap. The faucet should be located in a position that gives a flow of water into the sink bowl. Ensure (check) that you have enough room below the desired position to connect the tubing to the tap. Using a centre pop (or nail) mark where the centre of the tap stud will be and drill a 12mm hole through the surface. Secure the tap in place by using the fixing kit provided.

water-gem-layout.jpg

Carriage is free to UK mainland.

made-in-england.jpgwras-approved.jpg

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!