Everpure BW100 Under-sink Filter System

Everpure BW100 Under-sink Filter System

BW100 Drinking Water System with full installation kit.

Features

• The ultimate home under-sink filter system
• Complete system with tap, self tapping valve, quick change head and 12 month cartridge
• Removes chlorine, bad taste and odour for great tasting water
• Removes 99.9% iron, manganese oxide, rust, sulphur, lead, copper, cadmium, aluminium, asbestos fibres and parasites such as cryptosporidium
• Reduces scale
• Huge capacity cartridge with 12 month filter life

We now have a great Everpure Alternative under sink system in stock that is at a great price using a great taste/odour OCS2 filter and QL3B head, please call 01704 531556 for further details.

It is quite easy to fit this system yourself. A lot of people are under the misconception that they would need a plumber to fit the system which is not the case. The saddle valve that makes the connection from your cold water pipe is self- piercing and can be easily fitted yourself using the below instructions.

   Full instructions are provided with the system

 Identify the mains cold water pipe, using a section that is straight and free from paint, scratches or dents. Connect the saddle valve to the cold-water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. DO NOT OVER TIGHTEN. One or two spanner turns after finger tight should do. The aim is simply to make the saddle valve immovable on the pipe.

 Once saddle clamp is secured firmly on the pipe, turn the T bar tap on the saddle clamp clockwise until is stops turning. (This will pierce the pipe with a metal pin – invisibly). Turning the T bar tap a few turns back will allow the water flow. Only do this when you are ready to ‘start up’ the system.

The Faucet tap is also straight forward to fit by following the below instructions.

Select a position for the tap on the counter or sink shoulder, you may already have a removable cap that will reveal a hole for your tap. The faucet should be located in a position that gives a flow of water into the sink bowl. Ensure (check) that you have enough room below the desired position to connect the tubing to the tap. Using a centre pop (or nail) mark where the centre of the tap stud will be and drill a 12mm hole through the surface. Secure the tap in place by using the fixing kit provided.

Carriage is free to the UK mainland.