Loading... Please wait...
Need help? Call us on 01704 531556 Free UK delivery on all orders
Menu
  • Free UK Delivery on All Orders
  • 30 Day Hassle Free Returns
  • Expert Advice & Support

Taste Great Under-sink Filter System

by

|SKU: TG14
£27.95Inc. VAT
Availability: Usually dispatched within 24 hours. Free UK mainland delivery.

Product Description

The Taste Great Filter System is a brand new under-sink water filter system that is designed for a simple D.I.Y installation (with no hard plumbing required).

There is no other system on the market that offers this quality at this value and telephone support.

Save money and be more environmentally friendly by using our very popular Filter system.

The Taste Great system will improve the taste and odour of your mains water supply thereby eliminating the need for filter jugs or bottled water. The system also reduces chlorine and other chemicals found in mains water as well as stopping any rust or sediment from old pipes etc.

  • Produced in the UK.
  • WRAS approved materials.
  • Built in push-fits.
  • Expert telephone support available.
  • Great tasting water from your own tap.
  • full instructions provided with system for a D.I.Y fit.

This filter system does exactly what it says on the label, it provides Great Tasting fresh water!

An alternative to buying in bottled water and helping with the environmental fight against plastic pollution. The system also helps reduce any microplastics in your drinking water larger than 5 microns.

It is quite easy to fit this system yourself. A lot of people are under the misconception that they would need a plumber to fit the system which is not the case. The saddle valve that makes the connection from your cold water pipe is self- piercing and can be easily fitted yourself using the below instructions.

   Full instructions are provided with the system

 Identify the mains cold water pipe, using a section that is straight and free from paint, scratches or dents. Connect the saddle valve to the cold-water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. DO NOT OVER TIGHTEN. One or two spanner turns after finger tight should do. The aim is simply to make the saddle valve immovable on the pipe.

 Once saddle clamp is secured firmly on the pipe, turn the T bar tap on the saddle clamp clockwise until is stops turning. (This will pierce the pipe with a metal pin – invisibly). Turning the T bar tap a few turns back will allow the water flow. Only do this when you are ready to ‘start up’ the system.

The Faucet tap is also straight forward to fit by following the below instructions.

Select a position for the tap on the counter or sink shoulder, you may already have a removable cap that will reveal a hole for your tap. The faucet should be located in a position that gives a flow of water into the sink bowl. Ensure (check) that you have enough room below the desired position to connect the tubing to the tap. Using a centre pop (or nail) mark where the centre of the tap stud will be and drill a 12mm hole through the surface. Secure the tap in place by using the fixing kit provided.

Carriage is free to UK mainland.

made-in-england.jpgwras-approved.jpg

 

 

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!